Wall canopies
Single-sided hoods over a cook line, with a splash-back and overhang to suit the equipment depth.
Home / Products / Extraction hoods
Commercial extraction hoods, built to your cook line.
Wall and island canopies in 304 stainless, sized to the equipment underneath and the ducting above. Fully welded and polished with filter tracks, grease trays and lighting cut-outs ready for your ventilation installer.
The range
Canopies for cafés, restaurants and food plants.
We build the hood; your mechanical contractor does the fan, ducting and fire suppression. We coordinate the spigot sizes and positions so the two meet properly.
Island canopies
Four-sided hoods for open kitchens and central cook lines, with hanging brackets and light cut-outs.
Condensate hoods
Hoods over dishwashers and steam equipment, with internal gutters and drain points.
Residential rangehood shrouds
Custom stainless shrouds and canopies for domestic kitchens where an off-the-shelf hood will not fit.
Indicative pricing
Indicative extraction hood pricing.
Indicative range only. Final pricing depends on length, depth, wall or island style, filter count and finish. Fans, ducting and fire suppression are quoted by your mechanical contractor.
Custom extraction canopy
Hood only, delivered ready to hang.
$2,800from, + GST
Typically $2,800–$18,000 + GST depending on size
- 1.2 mm 304 stainless, fully welded
- Baffle filter tracks and removable grease trays
- Spigots sized to your ducting
- Light and sprinkler cut-outs to your layout
Filters, lights, fans and ducting are extra and usually supplied by the ventilation contractor.
Questions
Common questions about commercial extraction hoods.
Do you install the extraction system as well?
We fabricate and can hang the hood. The fan, ducting, make-up air and fire suppression are done by a mechanical services contractor, and we work to their spigot sizes and positions.
How much overhang does a hood need?
As a rule the canopy should extend at least 150 mm past the cooking equipment on each open side, and the mechanical design will confirm this. We size the hood to the drawing.
Can you replace an old rusted hood?
Yes. We measure the existing canopy and duct positions and build a like-for-like replacement in 304 stainless, usually installable in a single morning.
How it works
Spec, quote, fabricate, fit.
01
Spec
We confirm size, materials, the loadings or spec and how it will be used.
02
Quote
It is all priced before any steel is cut, so there are no surprises.
03
Fabricate
Built in the Patumahoe workshop to the agreed spec.
04
Fit
Delivered, fitted or installed and checked over before handover.
Also built here
Other things the workshop makes.
Got a job in mind? Let’s talk it through.
Send through photos, rough measurements and how it’ll be used — we’ll come back with a practical next step and a price.